Milenco Remote Alarm Fitting Guide

Table of Contents

1. Introduction and Features
2. Battery Replacement
3. Programming Additional Remotes
4. Operating Instructions

1. Introduction and Features The Milenco Remote Alarm (product code 1274) is designed to provide a secure and randomized code transmission to prevent thieves from copying and disarming your alarm system. The remote has two notable features:

• Channel 1 - Disarm
• Channel 2 - Arm/Panic
• LED Indicator - Shows when the button is being pressed

2. Battery Replacement To replace the batteries in the transmitter, gently separate the top and bottom covers with your fingers. Remove the old batteries and replace them with new ones, ensuring correct polarity. Never submerge the transmitter in water or get it wet, as this will void the warranty.

3. Programming Additional Remotes Follow these steps to program additional remotes:

4. Operating Instructions

1. Power on the "Car Alarm" for at least 10 seconds.
2. Press "Unlock."
3. Connect and disconnect the switch or cable for 10 cycles within 10 seconds, then keep it connected.
4. Press "Lock" to enter programming mode. You can program up to 3 remotes simultaneously.

The system will respond as follows:

• LED will flash 10 times.
• Siren Chip will sound once.
• First remote: LED will flash once, and the Siren Chip will emit one short beep.
• Second remote: LED will flash twice, and the Siren Chip will emit two short beeps.
• Third remote: LED will flash three times, and the Siren Chip will emit three short beeps.

The Siren Chip will sound twice when exiting programming mode. After programming all remotes, the programming mode will automatically turn off after 10 seconds.