Milenco Wraith 2 Wheel Clamp Lock Fitting Guide

THINK READ PLAN

Table of Contents:

1. Tools Required
2. Wheel Bolt Replacement
3. Wheel Lock Adjustment

1. Tools Required:

• 19mm Socket
• Torque Wrench

2. Wheel Bolt Replacement:

1. Remove one wheel bolt and replace with the supplied security wheel bolt receiver. (Image 1)
2. Using the torque wrench, tighten the security wheel bolt to vehicle manufacturers torque specification. (Image 2)

3. Wheel Lock Adjustment:

The Wraith Wheel Lock requires a one-off adjustment for optimum fitment for individual wheel sizes. This is achieved by following these simple steps.

1. Using the supplied Allen Key, turn the grub screw one turn counterclockwise, allowing the lock shaft to rotate for adjustment. (Image 3)
2. Turn the lock shaft counterclockwise to its maximum length (Image 4) and retighten the grub screw. THIS IS VERY IMPORTANT
3. Insert the leg into the slot on the body. Insert the key and turn it clockwise to unlock. (Image 5)
4. Locate the lock shaft onto the security wheel bolt receiver, aiming for a flush fit of the lock body to the wheel/tyre surface. If adjustment is needed, remove the lock from the wheel bolt receiver, loosen the grub screw, and rotate the lock shaft clockwise to shorten until a minimal gap between the lock body and wheel surface is achieved. Retighten the grub screw. (Image 6)
5. Turn the key counterclockwise to lock into position. Set up is now complete. (Image 7)

ENSURE GRUB SCREW IS TIGHTENED TO ENSURE LOCK SHAFT DOES NOT TURN WHILE TRYING TO LOCK / UNLOCK